Upload vibration measurement to skAIwatch

Owned by Geir Kulia (Unlicensed)
Last updated: 23 Aug 22 by Yngve Villanger
2 min read

Vibration measurements from handheld sensors can be uploaded to skAIwatch directly in the portal. Below follows a step by step procedure.

Go to Data upload to upload offline vibration measurements in skAIWatch, or directly to skAIWatch data upload. Its icon is shown in the figure below

Step 1

Select your vessel—the one to which the data file corresponds.

Step 2

Drag and drop the corresponding data file (ODX) in the data uploading field. One may also click on the area to trigger a file selection view. Leave this blank if data has been uploaded with skAILink, or if one only wants to upload running conditions.

Files added will be shown on the right side.

Step 3

Add additional relevant information that is related to the condition of the equipment or other relevant information one may have.

Step 4

If applicable add additional relevant files such as Word or PDF documents. The document is loaded in the same manner as in step 2.

Click submit to send the information to skAIWatch.

Verification

If the upload job is completed successfully an upload successful message is shown.

 

In case the upload job fails an error symbol as shown below is presented. In case of problems

  • Retry

  • Upload fewer or smaller files

  • Contact skAIwatch support